Required Tools; Preliminary Steps - Fujitsu PRIMERGY TX120 S3 Upgrade And Maintenance Manual

System board and components

14.4.1 Required tools

Preliminary and concluding steps: tool-less
●
Replacing the system board:
●
– Phillips PH2 / (+) No. 2 screw driver
– Recommended: Magnifying glass (for inspecting socket cover springs)
If an UFM is installed:
– Phillips PH1 / (+) No. 1 screw driver
If a TPM module is installed:
– Bit screw driver
– TPM bit insert *
– thin slotted screw driver (
*For the Japanese market:
– Dedicated TPM screw driver (CWZ8291A)
– TPM module fixing tool (S26361-F3552-L909)

14.4.2 Preliminary steps

I
For BIOS version 1.15 or below, automatic restore functionality of the
customer BIOS settings is not available. In this case, proceed as follows:
Ê Please note down the current configuration or ask the customer to
provide individual settings. Restore settings to the new system board
manually.
Ê If the BIOS version is unclear due to a defective system board, please
ask the customer to provide individual BIOS settings.
For all other BIOS versions, the customer BIOS settings are restored
automatically. For the Japanese market, please refer to the "Parameter
configuration sheet".
Before replacing the system board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
Ê Disable boot watchdog functionality as described in section
SVOM boot watchdog functionality" on page
348
2 x 0.4 mm)*
79.
Upgrade and Maintenance Manual
"Disabling BitLocker
"Disabling
80.
TX120 S3