System board and components
14.1.5 Concluding steps
Perform the following procedures to complete the task:
Ê Dispose of the CMOS battery in accordance with local regulations
concerning special waste.
Ê Close the server cover as described in section
page
70.
Ê Reconnect the AC power cord to the power supply unit.
14.2
USB Flash Module (UFM)
This section provides information on how to install, remove or replace the USB
Flash Module (UFM).
14.2.1 Installing the UFM board
Field Replaceable Units (FRU)
Average hardware task duration: 5 minutes
Average software task duration: 5 minutes
14.2.1.1 Required tools
Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Installing the UFM: tool-less
●
14.2.1.2 Preliminary steps
Before installing the UFM board, perform the following steps:
Ê Disable BitLocker functionality as described in section
functionality" on page
318
79.
Upgrade and Maintenance Manual
"Closing the server" on
"Disabling BitLocker
TX120 S3