View Ipv6 Gateway, Route, And Router Neighbors; Viewing Gateway And Ipv6 Route Information - HP PROCURVE 2910AL Configuration Manual

View IPv6 Gateway, Route, and Router
Neighbors
Use these commands to view the switch's current routing table content and
connectivity to routers per VLAN. This includes information received in router
advertisements from IPv6 routers on VLANs enabled with IPv6 on the switch.

Viewing Gateway and IPv6 Route Information

Syntax: show ipv6 route [ ipv6-addr ] [connected
This command displays the routes in the switch's IPv6 routing
table.
ipv6-addr: Optional. Limits the output to show the gateway to
the specified IPv6 address.
connected: Optional. Limits the output to show only the gate­
ways to IPv6 addresses connected to VLAN interfaces config­
ured on the switch, including the loopback (::1/128) address.
Dest: The destination address for a detected route.
Gateway: The IPv6 address or VLAN interface used to reach the
destination. (Includes the loopback address.)
Type: Indicates route type (static, connected, RIP, or OSPF).
Distance: The route's administrative distance, used to deter­
mine the best path to the destination.
Metric: Indicates the route cost for the selected destination.
IPv6 Addressing Configuration

View IPv6 Gateway, Route, and Router Neighbors

4-29