Ntp Ipv6-Multicast; Debug Ntp; Ntp Trap - HP Aruba JL253A Management And Configuration Manual

key-id
Set the authentication key to use for this server.
max-poll <max-poll-val>
Configure the maximum time intervals in seconds.
min-poll <min-poll-val>
Configure the minimum time intervals in seconds.

ntp ipv6-multicast

This command is used to configure NTP multicast on a VLAN interface.
Syntax
ntp ipv6-multicast
Description
Configure the interface to listen to the NTP multicast packets.
Example
Switch(vlan-2)# ntp
ipv6-multicast
Restrictions
Validation
If ipv6 is not enabled on vlan interface

debug ntp

This command is used to display debug messages for NTP.
Syntax
debug ntp <event |
packet>
Options
event
Displays event log messages related to NTP.
packets
Displays NTP packet messages.
Description
Enable debug logging. Use [no] to disable debug logging.
Example
Switch(config)# debug ntp
event
packet

ntp trap

This command is used to configure NTP traps.
56
Configure the interface to listen to the NTP multicast packets.
Display event log messages related to NTP.
Display NTP packet messages.
Aruba 2930F / 2930M Management and Configuration Guide
Error/Warning/Prompt
IPv6 address not configured on the
VLAN.
for ArubaOS-Switch 16.08