Static-Rpf-Peer; Timer Retry - HP 5900 Series Command Reference Manual

static-rpf-peer

Use static-rpf-peer to configure a static RPF peer.
Use undo static-rpf-peer to remove a static RPF peer.
Syntax
static-rpf-peer peer-address [ rp-policy ip-prefix-name ]
undo static-rpf-peer peer-address
Default
No static RPF peer is configured.
Views
MSDP view
Predefined user roles
network-admin
Parameters
peer-address: Specifies an MSDP peer by its IP address.
rp-policy ip-prefix-name: Specifies a filtering policy based on the RP addresses in SA messages. The
ip-prefix-name argument is the filtering policy name, a case-sensitive string of 1 to 63 characters.
Usage guidelines
When you configure multiple static RPF peers at the same time, observe the following rules:
If the rp-policy keyword is specified for all the static RPF peers, SA messages from the active static
•
RPF peers are filtered according to the configured filtering policy. The router receives only SA
messages that have passed the filtering.
If the rp-policy keyword is not specified for the static RPF peers, the router receives all SA messages
•
from the active static RPF peers.
Examples
# Configure a static RPF peer on the public network.
<Sysname> system-view
[Sysname] ip prefix-list list1 permit 130.10.0.0 16 greater-equal 16 less-equal 32
[Sysname] msdp
[Sysname-msdp] peer 130.10.7.6 connect-interface vlan-interface 100
[Sysname-msdp] static-rpf-peer 130.10.7.6 rp-policy list1
Related commands
• display msdp peer-status
ip prefix-list
•

timer retry

Use timer retry to configure the interval between MSDP peering connection attempts.
Use undo timer retry to restore the default.
183