Register-Whole-Checksum (Pim View) - HP 6125XLG Command Reference Manual

undo register-policy
Default
No register filtering rule is configured.
Views
PIM view
Predefined user roles
network-admin
Parameters
acl-number: Specifies an IPv4 advanced ACL, in the range of 3000 to 3999.
Usage guidelines
Use an IPv4 advanced ACL to filter register messages based on source addresses and multicast group
addresses. If you specify a VPN instance in the ACL, the ACL does not take effect. The other optional
parameters except the fragment keyword and the time-range keyword are ignored.
The RP accepts only register messages that match the permit statement of the ACL.
Examples
# Configure the RP to accept only those register messages from multicast sources on the subnet of
10.10.0.0/16 for multicast groups on the subnet of 225.1.0.0/16.
<Sysname> system-view
[Sysname] acl number 3000
[Sysname-acl-adv-3000] rule permit ip source 10.10.0.0 0.0.255.255 destination 225.1.0.0
0.0.255.255
[Sysname-acl-adv-3000] quit
[Sysname] pim
[Sysname-pim] register-policy 3000

register-whole-checksum (PIM view)

Use register-whole-checksum to configure the device to calculate the checksum based on an entire
register message.
Use undo register-whole-checksum to restore the default.
Syntax
register-whole-checksum
undo register-whole-checksum
Default
The device calculates the checksum based on the header of a register message.
Views
PIM view
Predefined user roles
network-admin
87