Dell PowerConnect W-7200 Series Reference Manual page 598

The output of this command includes the following information:
Parameter
host
Key
Acct Port
auth port
Retransmits
Timeout
NAS ID
NAS IP
Source Interface
Use MD5
Mode
The output of this command includes the following parameters:
Command History
Version
ArubaOS 3.0
ArubaOS 6.1
Command Information
Platforms
All platforms
598 | show aaa authentication-server radius
Description
IP address of the RADIUS server
Shared secret between the controller and the authentication server.
Accounting port on the server.
Authentication port on the server.
Maximum number of retries sent to the server by the controller before the server is marked
as down.
Maximum time, in seconds, that the controller waits before timing out the request and
resending it.
Network Access Server (NAS) identifier to use in RADIUS packets.
NAS IP address to send in RADIUS packets. If you do not configure a server-specific NAS
IP, the global NAS IP is used.
The source interface VLAN ID number.
If enabled, the RADIUS server will use a MD5 hash of cleartext password.
Shows whether this server is Enabled or Disabled.
Description
Command introduced.
The Source Interface parameter was introduced.
Licensing
Base operating system
Command Mode
Enable or Config mode on master or local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide