Dell PowerConnect W-7200 Series Reference Manual page 105

ap-leds
ap-leds
{all | ap-group <ap-group> | ap-name <ap-name> | ip-addr <ip address> | wired-mac <mac
address>} {global blink|normal}|{local blink|normal}
Description
This command allows you to set the behavior of an AP's LEDs.
Syntax
Parameter
all
ap-group <ap-group>
ap-name <ap-name>
ip-addr <ip-addr>
wired-mac <mac-addr>
global
local
blink
normal
Usage Guidelines
Use the ap-leds command to make the LEDs on a defined set of APs either blink or display in the currently
configured LED operating mode. Note that if the LED operating mode defined in the AP's system profile is set to
"off", then the normal parameter in the ap-leds command will disable the LEDs. If the LED operating mode in the
AP system profile is set to "normal" then the normal parameter in this command will allow the LEDs light as usual.
Example
The following command causes all local APs to blink their LEDs for identification purposes:
ap-leds all local blink
Command History
Release
ArubaOS 3.0
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Controls the LED behavior for all APs
Controls the LED behavior for APs in the specified group
Controls the LED behavior for the AP with the specified name
Controls the LED behavior for the AP with the specified IP address
Controls the LED behavior for the AP with the specified MAC address
Selects all APs on all controllers
Selects all APs registered on this controller
Causes the LEDs to blink for identification
Restores the LEDs to their normal behavior
Modification
Command introduced
ap-leds | 105