Dell PowerConnect W-7200 Series Reference Manual page 748

Parameter
Max received A-MPDU size
Min MPDU start spacing
Supported MCS set
Short guard interval in 40
MHz mode
VLAN
Forward mode
Band Steering
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
748 | show ap debug received-config
Description
Shows the maximum size, in bytes, of an Aggregated-MAC Packet Data Unit
(A-MPDU) that can be received on the AP's high-throughput SSID.
Displays the minimum time between the start of adjacent MDPUs within an
aggregate MDPU, in microseconds.
Comma-separated list of Modulation Coding Scheme (MCS) values or ranges
of values to be supported on this high-throughput SSID.
Shows if the AP has enabled or disabled use of short guard interval in 40 MHz
mode of operation.
VLAN ID used by the SSID.
Shows the current forward mode (bridge, split-tunnel, or tunnel) for the virtual
AP.
This parameter controls whether 802.11 frames are tunneled to the controller
using generic routing encapsulation (GRE), bridged into the local Ethernet LAN
(for remote APs), or a combination thereof depending on the destination
(corporate traffic goes to the controller, and Internet access remains local).
Only 802.1X authentication is supported when configuring bridge or split tunnel
mode.
Shows if band-steering has been enabled or disabled for a virtual AP.
ARM's band steering feature encourages dual-band capable clients to stay on
the 5GHz band on dual-band APs. This frees up resources on the 2.4GHz band
for single band clients like VoIP phones.
Band steering reduces co-channel interference and increases available
bandwidth for dual-band clients, because there are more channels on the
5GHz band than on the 2.4GHz band. Dual-band 802.11n-capable clients may
see even greater bandwidth improvements, because the band steering feature
will automatically select between 40MHz or 20MHz channels in 802.11n
networks. This feature is disabled by default, and must be enabled in a Virtual
AP profile.
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide