Table of Contents
Advertisement
Column
status
pkts
macs
gw-macs
tagged-pkts
vlan
Packets read
Bytes read
Num Intercepts
Num Buffer Overflows
Max PPS
Cur PPS
Max PPI
Cur PPI
Uptime
LMS IP
Master IP
AP type
Country Code
ap
sta
pap
psta
ch
msg-hash
ap-l
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Shows if the interface is currently enabled or disabled.
Number of packets seen on the AP's wired interface.
Number of MAC addresses in the Wired MAC table for that interface.
Number of MAC addresses in the Wired MAC table for that interface.
Number VLAN-tagged packets sent to that interface.
The VLAN ID for the packets sent to that interface.
Number of packets read by the AP since it was last reset.
Number of bytes read by the AP since it was last reset.
Number of interrupts from the AP's driver.
Number of times excessive traffic has filled the AP's buffers.
Maximum throughput rate seen on the interface, in packets per second.
Current throughput rate seen on the interface, in packets per second.
Maximum interrupt rate seen on the interface, in interrupts per second.
Current interrupt rate seen on the interface, in interrupts per second.
Number of seconds since the AP was last reset.
IP address of the AP's local controller.
IP address of the AP's master controller.
AP model type.
The AP's country code. Valid radio channels for your wireless network are based on your
country code. If you change the AP's country code, the valid channels will be reset to the
defaults for the new country.
Number of other APs monitored by this AP.
Number of clients and APs seen by this AP.
Number of potential APs; APs which have transmitted a beacon, but have not yet been
registered.
Number of potential stations; AP has seen a MAC address from the station but hasn't yet
received traffic from it.
Number of channel entries in the channel table.
Number of different message types seen on the interface.
(For internal use only)
show ap monitor debug | 815
Advertisement
Table of Contents
