Dell PowerConnect W-7200 Series Reference Manual page 818

show ap monitor stats
show ap monitor stats advanced {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
client-mac <client-mac>
show ap monitor stats {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>} mac <mac>
Description
Show packet, signal and channel statistics for an AP or a client.
Syntax
Parameter
advanced
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
mac <mac>
client-mac <client-mac>
Example
The output of the following command shows monitoring statistics for the AP al12, and a client with the MAC
address 00:03:2a:02:6a:d7.
(host) #show ap monitor stats ap-name al12 mac 00:03:2a:02:6a:d7
Aggregate Stats
---------------
retry low-speed
----- ---------
0 0
RSSI
----
avg-signal low-signal
---------- ----------
51 51
Monitored Time:6626
Last Packet Time:585500
Uptime:585502
DoS Frames
----------
tx old-tx rx
-- ------ --
0 0 0
Interference Baseline
---------------------
818 | show ap monitor stats
Description
Show advanced statistics for an AP or client.
Show statistics for an AP with a specific name.
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic
Service Set Identifier (BSSID) is usually the AP's MAC address.
Show data for an AP with a specific IP address by entering its IP address in dotted-
decimal format.
Show data for a specific MAC address by entering the MAC address of a client or AP.
Show data for a specific client MAC address by entering the MAC address of a client.
non-unicast recv-error
----------- ----------
0 0
high-signal
-----------
51
old-rx
------
0
frag bwidth
---- ------
0 0
count duration (sec)
----- --------------
4 50
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide