Ntp Server - Dell PowerConnect W-7200 Series Reference Manual

ntp server

#ntp server <server-ip> [iburst] [key <key-id>]
Description
This command configures a Network Time Protocol (NTP) server.
Syntax
Parameter
<ipaddr>
iburst
key <key-id>
Usage Guidelines
You can configure the controller to set its system clock using NTP by specifying one or more NTP servers.
Example
The following command configures an NTP server using the iburst optional parameter and using a key identifier
"123456."
(host) (config) #ntp server 10.1.1.245 iburst key 12345
Command History
Release
ArubaOS 1.0
ArubaOS 3.0
ArubaOS 6.1
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
IP address of the NTP server, in dotted-decimal format.
(Optional) This parameter causes the controller to send up to ten queries
within the first minute to the NTP server. This option is considered
"aggressive" by some public NTP servers.
This is the key identifier used to authenticate the NTP server. This needs
to match the key identifier configured in the
ntp authentication-key command.
Modification
Command introduced
The iburst parameter was introduced
The key parameter was introduced
Licensing
Base operating system
Command Mode
Config mode on master controllers
Default
—
disabled
—
ntp server | 459