Dell PowerConnect W-7200 Series Reference Manual page 664

show ap allowed-channels
show ap allowed-channels [<ap-name>|<country-code>|<ip-addr>]
Description
This command shows configuration information for Captive portal authentication profiles.
Syntax
Parameter
<ap-name>
<country-code>
<ip-addr>
Usage Guidelines
Specify the country code for your controller during initial setup. Changing the country code causes the valid channel
lists to be reset to the defaults for that country.
Examples
The output of this example shows all allowed channels for the country code US
(host)# show ap allowed-channels US
Allowed Channels for Country Code "US"
--------------------------------------
PHY Type
--------
802.11g (indoor)
802.11a (indoor)
802.11g (outdoor)
802.11a (outdoor)
802.11g 40MHz (indoor)
802.11a 40MHz (indoor)
802.11g 40MHz (outdoor)
802.11a 40MHz (outdoor)
Command History
Introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
664 | show ap allowed-channels
Description
Name of an AP.
Specify a country code to display allowed channels for that country.
IP address of an AP, in dotted-decimal format.
Allowed Channels
----------------
1 2 3 4 5 6 7 8 9 10 11
36 40 44 48 149 153 157 161 165
1 2 3 4 5 6 7 8 9 10 11
149 153 157 161 165
1-5 2-6 3-7 4-8 5-9 6-10 7-11
36-40 44-48 149-153 157-161
1-5 2-6 3-7 4-8 5-9 6-10 7-11
149-153 157-161
Licensing
Base operating system
Command Mode
Enable or Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide