Dell PowerConnect W-7200 Series Reference Manual page 689

show ap client status
show ap client status <client-mac>
Description
Show the current status of a specific client.
Syntax
Parameter
<client-mac>
Examples
The output of the command shows the status of an individual client in the STA (station) table.
(host) #show ap client status
STA Table
---------
bssid
-----
00:1a:1e:a3:02:c9
State Hash Table
----------------
bssid
-----
00:1a:1e:a3:02:c9
The output of this command includes the following information:
Column
bssid
auth
assoc
aid
l-int
essid
vlan-id
tunnel-id
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
MAC address of a client
00:13:fd:42:32:38
auth assoc aid l-int
---- ----- --- -----
y y 7 10
state reason
----- ------
auth-assoc 0
Description
Basic Service Set ID (BSSID) of the client.
This column displays a y if the AP has been configured for 802.11 authorization frame types.
Otherwise, it displays an n.
This column displays a y if the AP has been configured for 802.11 association frame types.
Otherwise, it displays an n.
Number of beacons in the 802.11 listen interval. There are ten beacons sent per second, so
a ten-beacon listen interval indicates a listen interval time of 1 second.
Number of beacons in the 802.11 listen interval. There are ten beacons sent per second, so
a ten-beacon listen interval indicates a listen interval time of 1 second.
Extended Service Set ID (ESSID) of the client.
VLAN ID of the VLAN used by the client
Identification number for the tunnel
essid vlan-id tunnel-id
----- ------- ---------
corp-wpa2 65 0x10c0
show ap client status | 689