Dell PowerConnect W-7200 Series Reference Manual page 486

usb-passwd <usb-passwd>
usb-power-mode auto|enable|disable
usb-tty <usb-tty>
usb-tty-control <usb-tty-control>
usb-type <usb-type>
usb-user <usb-user>
Description
This command provisions or reprovisions an AP.
Syntax
Parameter
a-ant-bearing
a-ant-gain
a-ant-tilt-angle
a-antenna
altitude
ap-group
ap-name
apdot1x-passwd
apdot1x-username
cellular_nw_preference
g-only|4g-only|
advanced|auto
486 | provision-ap
Description
Determines the horizontal coverage distance of the 802.11a (5GHz)
antenna from True North.
From a planning perspective, the horizontal coverage pattern does not
consider the elevation or vertical antenna pattern.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
Antenna gain for 802.11a (5GHz) antenna.
Directs the angle of the 802.11a (5GHz) antenna for optimum coverage.
Use a - (negative) value for downtilt and a + (positive) value for uptilt.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
Antenna use for 5 GHz (802.11a) frequency band.
1: Use antenna 1
l
2: Use antenna 2
l
both: Use both antennas (default)
l
Altitude, in meters, of the AP.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
Name of the AP group to which the AP belongs.
Name of the AP to be provisioned.
Password of the AP to authenticate to 802.1X using PEAP.
Username of the AP to authenticate to 802.1X using PEAP.
The Cellular Network Preference setting introduced in ArubaOS 6.2.1.0
allows you to select how the modem should operate.
auto (default): In this mode, modem firmware will control the cellular
l
network service selection; so the cellular network service failover
and fallback is not interrupted by the remote AP (RAP).
3g_only: Locks the modem to operate only in 3G.
l
4g_only: Locks the modem to operate only in 4G.
l
advanced: The RAP controls the cellular network service selection
l
based on an Received Signal Strength Indication (RSSI) threshold-
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Range
0-360 Dec-
imal
Degrees
—
-90 to +90
Decimal
Degrees
1, 2, both
(default)
—
—
—
—
—
—