Dell PowerConnect W-7200 Series Reference Manual page 147

Parameter
valid-11g-
channel
Usage Guidelines
This profile configures the country code and valid channels for operation of APs. The list of valid channels only
affects the channels that may be selected by ARM or by the controller when no channel is configured. Channels that
are specifically configured in the AP radio settings profile (see
be valid for the country and the AP model.
A controller shipped to certain countries, such as the U.S. and Israel, cannot terminate APs with regulatory domain
profiles that specify different country codes from the controller. For example, if a controller is designated for the U.S.,
then only a regulatory domain profile with the "US" country code is valid; setting APs to a regulatory domain profile
with a different country code will result in the radios not coming up. For controllers in other countries, you can mix
regulatory domain profiles on the same controller; for example, one controller can support APs in Japan, Taiwan,
China, and Singapore.
In order for an AP to boot correctly, the country code configured in the AP regulatory domain profile must match
the country code of the LMS. If none of the channels supported by the AP have received regulatory approval by the
country whose country code you selected, the AP will revert to Air Monitor mode.
Examples
The following command configures the regulatory domain profile for APs in Japan:
(host) (config) #ap regulatory-domain-profile rd1
country-code JP
The following command configures a regulatory domain profile for APs in the United States and specifies that the
channel pair of 36 and 40, is allowed for 40 MHz mode of operation on the 5 GHz frequency band:
(host) (config) #ap regulatory-domain-profile usa1
country-code US
valid-11a-40mhz-channel-pair 36-40
The following command configures a regulatory domain profile for APs in the United States and specifies that the
channel pair of 5 and 1, is allowed for 40 MHz mode of operation on the 2.4 GHz frequency band:
(host) (config) #ap regulatory-domain-profile usa1
country-code US
valid-11g-40mhz-channel-pair 1-5
Related Commands
To view the supported channels, use the show ap allowed-channels command.
AP configuration settings related to the IEEE 802.11n standard are configurable for Dell's W-AP120 series access
points, which are IEEE 802.11n standard compliant devices.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
1-5
2-6
7-11
Enter a single 802.11g channel number for 20 MHz
operation within the specified regulatory domain.
Range
for the country.
country code determines
supported channels
Note: Changing the country
code causes the valid channel
lists to be reset to the defaults
for the country.
rf dot11a-radio-profile or rf
Default
dot11g-radio-profile) must
ap regulatory-domain-profile | 147