Dell PowerConnect W-7200 Series Reference Manual page 724

Rx 36 Mbps
Rx 48 Mbps
Rx 54 Mbps
Rx WMM [BE]
The output of this command includes the following information:
Parameter
Frames Rcvd For TX
Tx Frames Dropped
Frames Transmitted
Success With Retry
Tx Mgmt Frames
Tx Probe Responses
Tx Data Frames
Tx CTS Frames
Dropped After Retry
Dropped No Buffer
Missed ACKs
Long Preamble
Short Preamble
Tx EAPOL Frames
Tx <n> Mbps
Tx WMM
UAPSD OverflowDrop
Last SNR
Last SNR CTL0
Last SNR CTL1
Last SNR CTL2
724 | show ap debug client-stats
13
1162
1730
39
Description
Number of frames received for transmission.
Number of transmission frames that were dropped.
Number of frames successfully transmitted.
Number of frames that were transmitted after being retried.
Number of management frames transmitted.
Number of transmitted probe responses.
Number of transmitted data frames.
Number of clear-to-sent (CTS) frames transmitted.
Number of frames dropped after an attempted retry.
Number of frames dropped because the AP's buffer was full.
Number of missed acknowledgements (ACKs)
Number of frames sent with a long preamble.
Number of frames sent with a short preamble.
Number of Extensible Authentication Protocol over LAN (EAPOL) frames transmitted.
Number of frames transmitted at <n> Mbps, where <n> is a value between 6 and 300.
Number of Wifi Multimedia (WMM) packets transmitted for the following access
categories. If the AP has not transmitted packets in a category type, this data row will not
appear in the output of the command.
Tx WMM [BE]: Best Effort
Tx WMM [BK]: Background
Tx WMM [VO]: VoIP
Tx WMM [VI]: Video
Number of packets dropped due to Unscheduled Automatic Power Save Delivery (U-APSD)
overflow.
The last recorded signal-to-noise ratio.
The signal-to-noise ratio for the last received data packet on the primary (control) channel
0. This parameter is only displayed for APs operating in 40 Mhz mode.
The signal-to-noise ratio for the last received data packet on the secondary (control)
channel 1. This parameter is only displayed for APs operating in 40 Mhz mode.
The signal-to-noise ratio for the last received data packet on the secondary (control)
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide