Dell PowerConnect W-7200 Series Reference Manual page 504

uplink {cellular priority <prior>}|disable|enable|{wired priority <prior>}|{wired vlan
<id>}
validate
<id> [<description>]|[<name> <vlan-ids>]|[range <range>]|[wired aaa-
vlan
profile <profile>]
vrrp <id> {advertise <interval>|authentication <password>|description <text>|ip address
<ipaddr>|preempt|priority <level>|shutdown} tracking interface {fastethernet
<slot>/<port>|gigabitethernet <slot>/<port>}{sub <value>}|tracking master-up-time
<duration> add <value>|tracking vlan <vlanid> {sub <value>}|tracking vrrp-master-state
<vrid> add <value>|vlan <vlanid>}
Description
The remote-node-profile command lets you create a Remote Node profile. Once in Remote Node profile
configuration mode, you can issue any of the following commands to define the values you want to assign to that
profile.
Syntax
Parameter
aaa
cellular profile <name>
clone <profile-name>
controller-ip vlan <id> ip address
dialer group <name>
instance
interface
504 | remote-node-profile
Description
Configure authentication server using an internal server. For details,
"aaa authentication-server internal" on page
see
Cellular interface profile associated with this Remote Node profile. For
details, see "cellular profile" on page
Use this command to copy a Remote Node profile to this profile.
Select one of the following parameters for the VLAN interface
dhcp-client: The remote node will use DHCP to obtain IP address
internal: Then remote node IP will be derived from the remote node
DHCP pool.
pppoe: Use PPPoE to obtain IP address
Dialer group profile associated with this Remote Node profile.
Configure the Remote Node MAC address to associate the Remote
Node to this profile. When you create a new Remote Node profile,
enter the remote-node profile instance command first.
Configure the Remote Node interface
cellular—Configure the cellular Interface.
l
fastethernet—Configure the FastEthernet (IEEE 802.3) interface.
l
gigabitethernet—Configure the GigabitEthernet Interface.
l
loopback—Configure the Loopback Interface.
l
port-channel—Configure the Ethernet channel of interfaces.
l
tunnel—Configure the Tunnel interface.
l
vlan —Configure the Switch VLAN Virtual Interface.
l
NOTE: The VLAN ID mapped using the "interface vlan <id> ip address"
command can use the following parameters to define how the
controller-ip is derived:
dhcp-client: The remote node will use DHCP to obtain
n
IP address
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
29.
174.