Dell PowerConnect W-7200 Series Reference Manual page 172

boot
boot
cf-test [fast | read-only | read-write]
config-file <filename>
remote-node [all|ip-address <A.B.C.D]
system partition [0 | 1]
verbose
Description
Configure the boot options for the controller and the remote node.
Syntax
Parameter
cf-test
fast
read-only
read-write
config-file
<filename>
remote-node
all
ip address
<A.B.C.D>
system 0 | 1
verbose
Usage Guidelines
Use the following options to control the boot behavior of the controller:
—Test the flash during boot.
l cf-test
l config-file
—Specify the system partition to use during the controller's next boot (login).
system
l
—Print extra debugging information during boot. The information is sent to the screen at boot time.
l verbose
Printing the extra debugging information is disabled using the
Example
The following command uses the configuration file january-config.cfg the next time the controller boots:
boot config-file january-config.cfg
172 | boot
Description
Sets the type of compact flash test to run when booting the controller.
Performs a fast test, which does not include media testing.
Performs a read-only media test.
Performs a read-write media test.
Sets the configuration file to use when booting the controller.
Specifies the name of the configuration file from which to boot the controller.
Reloads the remote node controller.
Reloads all remote nodes on the network.
Reloads on the remote node specified by its IP address.
Enter the keyword system followed by the partition number (0 or 1) that you want the
controller to use during the next boot (login) of the controller.
NOTE: A controller reload is required before the new boot partition takes effect.
Prints extra debugging information at boot.
—Set the configuration file to use during boot.
command.
no boot verbose
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide