Related Commands - Dell PowerConnect W-7200 Series Reference Manual

Parameter
xsec
point-to-point
allowed vlan
mtu
vlan
Usage Guidelines
Use the show port status command to obtain information about the interfaces available on the controller.
Example
The following commands configure an interface as a trunk port for a set of VLANs:
(host) (config) # interface fastethernet 1/2
(host) (config-range)# switchport mode trunk
(host) (config-range)# switchport trunk native vlan 10
(host) (config-range)# switchport trunk allowed vlan 1,10,100
The following commands configure trunk port 1/2 with test-acl session for VLAN 2.
(host) (config) # interface range fastethernet 1/2
(host) (config-range)# switchport mode trunk
(host) (config-range)# ip access-group
(host) (config-range) # ip access-group test session vlan 2

Related Commands

(host) #show interface {fastethernet|gigabitethernet} <slot>/<port>
(host) #show datapath port vlan-table <slot>/<port>
316 | interface fastethernet | gigabitethernet
Description
vlan command to explicitly make an individual VLAN
untrusted. The no trusted vlan command is additive and adds
given vlans to the existing untrusted vlan set.
However, if you execute the trusted vlan <word> command, it
overrides any earlier untrusted VLANs or a range of untrusted
VLANs and creates a new set of trusted VLANs.
NOTE: A port supports a user VLAN range from 1-4094. If you
want to set all VLANs (1-4094) on a port as untrusted then
mark the port itself as untrusted. By default the port and all its
associated VLANs are trusted.
Enables and configures the Extreme Security (xSec) protocol.
NOTE: You must purchase and install the xSec software
module license in the controller.
MAC address of the controller that is the xSec tunnel
termination point, and the 16-byte shared key used to
authenticate the controllers to each other. The key must be
the same on both controllers.
VLANs that are allowed on the xSec tunnel.
(Optional) MTU size for the xSec tunnel.
xSec VLAN ID. For controller-to-controller communications,
both controllers must belong to the same VLAN.
Range
—
—
—
—
1-4094
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Default
—
—
—
—
—