Table of Contents
Advertisement
Parameter
copy-provisioning-params
dns-server-ip
dns-server-ip6
domain-name
external-anten
na
fqln
g-ant-bearing
g-ant-gain
g-ant-tilt-angle
g-antenna
gateway
gateway6
ikepsk
installation
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
based approach. Initially the modem is set to the default auto mode.
This allows the modem firmware to select the available network.
The RAP determines the RSSI value for the available network type
(for example 4G), checks whether the RSSI is within required range,
and if so, connects to that network. If the RSSI for the modem's
selected network is not within the required range, the RAP will then
check the RSSI limit of an alternate network (for example, 3G), and
reconnect to that alternate network. The RAP will repeat the above
steps each time it tries to connect using a 4G multimode modem in
this mode.
Initializes the provisioning-params workspace with the current
provisioning parameters of the specified AP, The provisioning
parameters of the AP must have previously been retrieved with the read-
bootinfo option.
NOTE: This parameter can only be used on the master controller.
IP address of the DNS server for the AP.
IPv6 address of the DNS server for the AP.
Domain name for the AP.
Use an external antenna with the AP.
Fully-qualified location name (FQLN) for the AP, in the format
<APname.floor.building.campus>.
Determines the horizontal coverage distance of the 802.11g (2.4GHz)
antenna from True North.
From a planning perspective, the horizontal coverage pattern does not
consider the elevation or vertical antenna pattern.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
Antenna gain for 802.11g (2.4GHz) antenna.
Directs the angle of the 802.11g (2.4GHz) antenna for optimum coverage.
Use a - (negative) value for downtilt and a + (positive) value for uptilt.
NOTE: This parameter is supported on outdoor APs only. If you use this
parameter to configure an indoor AP, an error message is displayed.
Antenna use for 2.4 GHz (802.11g) frequency band.
1: Use antenna 1
l
2: Use antenna 2
l
both: Use both antennas
l
IP address of the default gateway for the AP.
IPv6 address of the default gateway for the AP.
IKE preshared key for the AP.
Specify the type of installation (indoor or outdoor). The default parameter
automatically selects an installation mode based upon the AP model
type.
Range
—
—
—
—
—
—
0-360 dec-
imal
degrees
—
-90 to +90
Decimal
Degrees
1, 2, both
—
—
—
default
indoor
outdoor
provision-ap | 487
Advertisement
Table of Contents
