Dell PowerConnect W-7200 Series Reference Manual page 471

Parameter
clear
pause
resume
start
stop
<am-ip>
<id>
bssid
<bssid>
Usage Guidelines
These commands direct an Dell air monitor to send packet captures to the Wildpacket's AiroPeek monitoring
application on a remote client. The AiroPeek application listens for packets sent by the air monitor.
The following pcap commands are available:
Command
clear
pause
resume
start
stop
Before using these commands, you need to start the AiroPeek application on the client and open a capture window
for the air monitor. The AiroPeek application cannot be used to control the flow or type of packets sent from Dell
air monitors.
The AiroPeek application processes all packets, however, you can apply display filters on the capture window to
control the number and type of packets being displayed. In the capture window, the time stamp displayed
corresponds to the time that the packet is received by the client and is not synchronized with the time on the Dell
air monitor.
Example
The following command starts a raw packet capture session for the air monitor at 10.100.100.1 and sends the
packets to the client at 192.168.22.44 on port 604 with pcap format:
(host) (config) #pcap raw-start 10.100.100.1 192.168.22.44 604 0
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Clears the packet capture session.
Pause a packet capture session.
Resume a packet capture session.
Start a new packet capture session.
Stop a packet capture session.
IP address of the air monitor collecting packets.
ID of the PCAP session.
(Optional) Specify the BSSID of the Air Monitor interface for the PCAP session.
BSSID of the Air Monitor Interface, which is usually its MAC address.
Description
Clears the packet capture session.
Pause a packet capture session.
Resume a packet capture session.
Start a new packet capture session.
Stop a packet capture session.
pcap (deprecated) | 471