Dell PowerConnect W-7200 Series Reference Manual page 819

FRR FRER
--- ----
17 4
Handoff Assist
--------------
rssi-index cur-signal
---------- ----------
0 51
High Throughput Parameters
--------------------------
ht-type primary-channel
------- ---------------
none 0
The output of this command includes the following information:
Column
retry
Low-speed
non-unicast
recev-error
frag
bwth
avg-signal
Low-signal
high-signal
count
Duration
tx
old-tx
rx
old-rx
FRR
FRER
rssi-index
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
old-cur-signal
--------------
0
sec-channel gf-supported
----------- ------------
0 0
Description
Percent of 802.11 retry frames sent because a client failed to send an ACK.
Percent of frames sent at a data rate of 18 Mbps or slower.
Percent of non-unicast frames
Percent of error frames of all frames seen in the last second.
Rate of fragmented packets, in frames per second
Current bandwidth, in bps.
Average signal-to-noise ratio over the interval since the AP's last reset.
Lowest signal-to-noise ratio over the interval since the AP's last reset.
Highest signal-to-noise ratio over the interval since the AP's last reset.
Number of packets seen on the AP over the interval since the AP's last reset.
Time over which the AP has measured RSSI values.
The total number of deauthorization frames sent to this MAC address for containment in the
interval from the AP's last reset until the current timer tick.
The total number of deauthorization frames sent to this MAC address for containment until
the previous timer tick.
The total number of deauthorization frames spoofing the MAC address in the interval from
the AP's last reset until the current timer tick.
The total number of deauthorization frames sent to this MAC address for containment until
the previous timer tick.
Frame retry rate, in frames per second.
Frame error retry rate, in frames per second.
This value indicates the number of consecutive timer ticks over which the value of the
Receive Signal Strength Indicator (RSSI) of the client has reduced by more than 3 units.
40mhz-intolerance
-----------------
0
show ap monitor stats | 819