Dell PowerConnect W-7200 Series Reference Manual page 957

Parameter
station-list
table
user
ap-name <ap-name>
counters
ip-addr <ip-address>
ipv4
ipv6
table
utilization
vlan
ap-name <ap-name>
ip-addr <ip-address>
table
vlan-mcast
ap-name <ap-name>
ip-addr <ip-address>
table
wifi-reassembly counters
wmm counters
Usage Guidelines
Use the show datapath command to display various datapath statistics for debugging purposes.
Example
The following example displays a partial list of cyrpto parameter statistics.
.(host) (config) #show datapath crypto counters
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Displays the list of stations on the tunnel.
Tunnel table statistics.
Displays datapath user statistics such as current entries, pending deletes, high
water mark, maximum entries, total entries, allocation failures, invalid users and
maximum link length.
Name of AP.
User counters.
IP address of the AP.
Displays datapath IPv4 user entries and statistics such as current entries, pending
deletes, high water mark, maximum entries, total entries, allocation failures,
invalid users, and maximum link length.
Displays datapath IPv6 user entries and statistics such as current entries, pending
deletes, high water mark, maximum entries, total entries, allocation failures,
invalid users, and maximum link length.
User table statistics.
Displays the current CPU utilization of all datapath CPUs.
Displays VLAN table information such as VLAN memberships inside the datapath
including L@ tunnels which tunnel L2 traffic.
Name of the AP.
IP address of AP.
Displays VLAN number, flag, port and datapath VLAN multicast entries.
Displays the datapath VLAN multicast table.
Name of the AP.
IP address of AP.
Displays datapath VLAN Multicast table entries.
Displays wifi reassembly counters including CPU, current entries, high water-
mark, maximum entries, total entries and allocation failures.
Displays VOIP statistics including the number of uplink and downlink resets.
show datapath | 957