Dell PowerConnect W-7200 Series Reference Manual page 477

pkt-trace
pkt-trace acl <acl-name> {enable|disable} [trace {cptrace|pktrace} [trace-mask <tmask>]]]
Description
Enable packet tracing in the datapath. Use this feature only under the supervision of Dell technical support.
Syntax
Parameter
<acl-name>
enable
disable
cptrace
pktrace
tracemask <tmask>
Example
The following example enables packet tracing for the traffic matching the acl stateful-dot1x.
(host) #pkt-trace acl stateful-dot1x enable trace cptrace trace-mask <val>
Command History
This command was introduced in ArubaOS 3.4.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Enable packet tracing for the specified access-control list.
Enable packet tracing for the ACL.
Disable packet tracing for the ACL.
Send packet trace data into the Control Processor.
Write packet trace data in the packet.
Specify the trace mask. This value will be provided by Dell technical support.
Licensing
Base operating system
Command Mode
Enable mode on master controllers
pkt-trace | 477