Table of Contents
Advertisement
Column
WMS on Master
Stats Update Interval
Poll Interval
Num Switches
Collect Stats
Bssid
Type
Status
Last-reg
N-reg
Last-update
Next-update
N-updates
Last-ack
Type
Server IP
Port
Frequency
Active
Command History
Version
ArubaOS 3.0.
ArubaOS 3.4.
816 | show ap monitor debug
Description
Indicates if the AP communicates to the wms process on a master or local controller.
enabled: Communicates with a master controller.
disabled: Communicates with a local controller only.
If the AP is collecting statistics, this value is the interval in seconds in which the AP sends
statistics to the WMS process on a controller.
Interval, in milliseconds, that the AP sends RSSI updates to the WMS process on a
controller.
Number of controllers to which this AP has access. If the value is 1, the AP has access to a
master or a local controller. If the value is 2, the AP has access to a master and a local
controller.
If enabled, the AP will collect statistics to send the WMS process on its controller.
BSSID of the radio.
Indicates whether the controller type is master or local.
If up, the AP can reach the controller. If down, the AP cannot reach the controller.
The time the AP last registered with the WMS process.
Number of times the AP has registered with the WMS process.
The last timer tick time the AP updated the WMS process.
Interval between the last update and the next scheduled update.
Number of updates sent to the WMS process.
Number of timer ticks since the AP received an acknowledgement from the WMS process.
Type of RTLS server used by the AP, such as MMS or Aeroscout.
IP address of the RTLS server.
Port used by the RTLS server.
Rate, in seconds, at which RTLS messages are sent to the server.
Indicates if the server is active on the AP.
Modification
Command introduced
The tagged-pkts and vlan parameters were added to the Wired Interface table in the
output of the show ap monitor debug status command.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Advertisement
Table of Contents
