Interface Vlan - Dell PowerConnect W-7200 Series Reference Manual

interface vlan

interface vlan <vlan>
bandwidth-contract <name>
bcmc-optimization
description <string>
ip address {<ipaddr> <netmask>|dhcp-client|{internal}|pppoe}|helper-address
<ipaddr>|igmp|local-proxy-arp|[nat inside]|{ospf area <id>}routing}| pppoe-max-segment-
site <number>| pppoe-password|pppoe-service-name|pppoe-username|routing
ipv6 {address <ipv6-address> link-local | [<ipv6-prefix>/<prefix-length> | eui-64]| mld
[snooping] | nd {ra [dns | enable | hop-limit | interval | life-time | managed-config-flag
| mtu | other-config-flag | preference | prefix] | reachable-time <value> | retransmit-
time <value>}}
mtu
multimode-auth
no ...
operstate up
option-82 mac essid
shutdown
suppress-arp
Description
This command configures a VLAN interface.
Syntax
Parameter
vlan
bandwidth-contract
bcmc-optimization
description
ip
address
330 | interface vlan
Description
VLAN ID number.
Name of the bandwidth contract to be applied to
this VLAN interface. When applied to a VLAN, the
contract only limits multicast traffic and does not
affect other data. Use the aaa bandwidth-contract
command to configure a bandwidth contract.
Enables broadcast and multicast traffic
optimization to prevent flooding of broadcast and
multicast traffic on VLANs. If this feature is
enabled on uplink ports, any controller-generated
Layer-2 packets will be dropped.
String that describes this interface.
Configures IPv4 for this interface.
Configures the IP address for this interface, which
can be one of the following:
<ipaddr> <netmask>
dhcp-client: use DHCP to obtain the IP
l
address
internal: IP address allocated from the
l
Remote Node Profile.
pppoe: use PPPoE to obtain the IP address
l
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Defau-
Range
lt
1-4094 —
— —
— dis-
abled
— 802.1Q
VLAN
— —