Dell PowerConnect W-7200 Series Reference Manual page 792

show ap mesh debug provisioned-clusters
show ap mesh debug provisioned-clusters {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-
addr>}
Description
Show cluster profiles provisioned on a mesh portal or mesh point.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
Example
The output of the command below shows statistics for the AP's mesh cluster profile and recovery cluster profile.
(host) #show ap mesh debug provisioned-clusters ap-name portal2
AP Portal Cluster Profile: mesh-cluster-profile
-------------------------------------------------
-------------------------
Parameter
---------
Cluster Name
RF Band
Encryption
WPA Hexkey
WPA Passphrase
AP "Portal" Cluster Profile: Recovery Cluster Profile
-----------------------------------------------------
Item
----
Cluster Name
RF Band
Encryption
WPA Hexkey
WPA Passphrase
The output of this command displays the following information for the AP's mesh cluster profile and recovery cluster
profiles:
Column
Cluster Name
RF band
792 | show ap mesh debug provisioned-clusters
Description
Show data for a mesh node with a specific name.
Show data for a mesh node with a specific Basic Service Set Identifier (BSSID). The Basic
Service Set Identifier (BSSID) is usually the AP's MAC address.
Show data for a mesh node with a specific IP address by entering an IP address in dotted-
decimal format.
Value
-----
sw-ad-GB32
a
opensystem
N/A
********
Value
-----
Recovery-ZF-xAPl5z-g15VN
a
pa2-psk-aes
********
N/A
Description
Name of the mesh cluster using this profile
The RF band in which the AP should operate:
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide