Dell PowerConnect W-7200 Series Reference Manual page 505

Parameter
ip
ipv6
logging
mgmt-server
mgmt-user
mobility-manager
model <model_type>
no
priority-map <name>
remote-node-dhcp-pool <pool_name>
pool-type {vlan <id>}|tunnel
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
internal: Then remote node IP will be derived from the
n
remote node DHCP pool.
pppoe: Use PPPoE to obtain IP address
n
For details on using this command,
see "interface fastethernet | gigabitethernet" on page 314
Configure the Interface Internet Protocol configuration sub commands.
For details, see command descriptions beginning with
gateway" on page 358.
default-gateway
l
domain lookup
l
domain-name
l
name-server
l
nat
l
radius
l
route
l
Configure the Global IPv6 configuration sub commands. For details,
see command descriptions beginning with
enable
l
route X:X:X:X::X/<0-128>
l
Set the logging level up to which messages are logged.
A.B.C.D
l
facility
l
level
l
For details on using this command, see
Register Mgmt Server IP Address with the controller.This could be
AirWave Management Server or any other server that would like to
receive messages from the controller using AMON protocol. For
details on using this command, see
Configure a management user. For details on using this command, see
"mgmt-user" on page 441.
Configure a mobility manager. For details on using command, see
"mobility-manager" on page 444.
Controller model associated to the Remote Node profile, where
<model-type> is one of the following controller model types:
W-3200
l
W-3400
l
W-3600
l
W-620
l
W-650
l
Delete a remote node profile.
Priority Map specification, used to prioritize the incoming packets on
an interface. For details on using this command, see
page 481.
Name of the DHCP pool.
Specify whether you are creating a pool of IP addresses for RN VLANs
"ip default-
"ipv6 enable" on page 342.
"logging" on page 426
"mgmt-server" on page 440.
"priority-map" on
remote-node-profile | 505