Table of Contents
Advertisement
Parameter
switchport
access
mode
trunk allowed
trunk native
trusted
wired-ap-enable
Usage Guidelines
This command is only applicable to Dell APs that support a second Ethernet port. The wired AP profile configures
the second Ethernet port (enet1) on the AP.
For mesh deployments, this command is applicable to all Dell APs configured as mesh nodes. If you are using mesh
to join multiple Ethernet LANs, configure and enable bridging on the mesh point Ethernet port.
Mesh nodes only support bridge mode and tunnel mode on their wired ports (enet0 or enet1). Split tunnel mode is
not supported.
Use the bridge mode to configure bridging on the mesh point Ethernet port. Use tunnel mode to configure secure
jack operation on the mesh node Ethernet port.
When configuring the Ethernet ports on APs with multiple Ethernet ports, note the following requirements:
If configured as a mesh portal, connect enet0 to the controller to obtain an IP address. The wired AP profile
l
controls enet1.Only enet1 supports secure jack operation.
If configured as a mesh point, the same wired AP profile will control both enet0 and enet1.
l
Example
The following command configures the enet1 port on a multi-port AP as a trunk port:
(host) (config) #ap wired-ap-profile wiredap1
switchport mode trunk
switchport trunk allowed 4,5
Command History
Release
ArubaOS 3.0
ArubaOS 3.2
ArubaOS 6.0
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Configures the switching mode characteristics for the port.
The VLAN to which the port belongs. The default is VLAN 1.
The mode for the port, either access or trunk mode. The default is access mode.
Allows multiple VLANs on the port interface.
You must define this parameter using VLAN IDs or VLAN names
VLAN IDs and VLAN names cannot be listed together.
The native VLAN for the port (frames on the native VLAN are not tagged with 802.1q tags).
Sets port as either trusted or untrusted. The default setting is untrusted.
Enables the wired AP. The wired AP is disabled by default.
Modification
Command introduced
The split-tunnel forwarding mode was introduced.
Wired ports on campus APs support bridge forwarding mode.
ap wired-ap-profile | 163
Advertisement
Table of Contents
