Dell PowerConnect W-7200 Series Reference Manual page 100

am
am scan <ipaddr> <channel> [bssid <bssid>]
am test <ipaddr> {suspect-rap bssid <bssid> match-type <match-type> match-method
<method>|wired-mac {add|remove {bssid <bssid>|enet-mac <enet-mac>} mac <mac>}
Description
These commands enable channel scanning or testing for the specified air monitor.
Syntax
Parameter
scan
<channel>
bssid
test
suspect-rap
match-type
match-method
wired-mac
enet-mac
mac
Usage Guidelines
These commands are intended to be used with an Dell AP that is configured as an air monitor. You should not use
the am test command unless instructed to do so by an Dell representative.
Example
The following command sets the air monitor to scan all channels:
(host) (config) #am scan 10.1.1.244 0
Command History:
Release
ArubaOS 3.0
ArubaOS 3.3.1
100 | am
Description
IP address of the air monitor to be scanned.
Channel to which the scanning is tuned. Set to 0 to
enable scanning of all channels.
BSSID of the air monitor.
IP address of the air monitor to be tested.
Tests suspect-rap feature.
Match type.
Match method.
Tests the rogue AP classification feature.
Specifies the Wired MAC table.
Specifies the Ethernet MAC table.
Specifies the MAC entry to add/remove from either the
Wired MAC table or the Ethernet MAC table.
Modification
Command introduced
Support for the wired-mac and associated parameters was introduced.
Range
—
—
—
—
—
eth-wm | ap-wm | eth-gw-wm
equal | plus-one | minus-one
—
—
—
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide