Dell PowerConnect W-7200 Series Reference Manual page 129

ap mesh-ht-ssid-profile
ap mesh-ht-ssid-profile <profile-name>
40MHz-enableba-amsdu-enable
clone <source>
high-throughput-enable
ldpc
legacy-stations
max-rx-a-mpdu-size
max-tx-a-mpdu-size
min-mpdu-start-spacing
mpdu-agg
no
short-guard-intvl-20Mhz
short-guard-intvl-40Mhz
stbc-rx-streams
stbc-tx-streams
supported-mcs-set
txbf-comp-steering
txbf-delayed-feedback
txbf-explicit-enable
txbf-immediate-feedback
txbf-noncomp-steering
txbf-sounding-interval
Description
This command configures a mesh high-throughput SSID profile used by mesh nodes.
Syntax
Parameter
<profile-name>
40MHz-enable
ba-amsdu-enable
clone <source>
high-throughput-
enable
ldpc
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Enter the name of an existing mesh high-throughput
SSID profile to modify that profile, or enter a new
name or create a new mesh high-throughput profile.
The mesh high-throughput profile can have a
maximum of 32 characters.
To view existing high-throughput SSID radio profiles,
use the command show ap mesh-radio-profile.
Enable or disable the use of 40 MHz channels. This
parameter is enabled by default.
Enable/Disable Receive AMSDU in BA negotiation.
Copy configuration information from a source profile
into the currently selected profile
Enable or disable high-throughput (802.11n) features
on this SSID. This parameter is enabled by default.
If enabled, the AP will advertise Low-density Parity
Check (LDPC) support. LDPC improves data
transmission over radio channels with high levels of
Range Default
default
enabled
disabled
enabled
enabled
ap mesh-ht-ssid-profile | 129