Dell PowerConnect W-7200 Series Reference Manual page 627

Arubaos 6.2
Hide thumbs Also See for PowerConnect W-7200 Series:
Table of Contents

Advertisement

Parameter
MAC
VPN
802.1x
Krb
RadAcct
SecureID
Stateful-802.1x
Management
Idled users
Mobility
fast age
Bandwidth contracts
IP takeovers
Ping/SYN/Session attacks
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Total number of MAC authentications or authentication failures since the last
controller reset.
Total number of VPN authentications or authentication failures since the last
controller reset.
Total number of 802.1X authentications or authentication failures since the last
controller reset.
Total number of Kerberos authentications or authentication failures since the last
controller reset.
Total number of RADIUS accounting verifications or accounting failures since
the last controller reset.
Number of authentication verifications or failures using methods which use one-
time passwords. (For example, EAP-GTC being used as the inner EAP protocol of
EAP-PEAP.)
Total number of Stateful 802.1X authentications or authentication failures since
the last controller reset.
Total number of Management user authentications or authentication failures
since the last controller reset.
Total number of users that are not broadcasting data to an AP.
Shows whether the IP mobility feature has been enabled or disabled on the
controller.
When the fast age feature allows the controller actively sends probe packets to
all users with the same MAC address but different IP addresses. The users that
fail to respond are purged from the system. This parameter shows if fast aging of
user table entries has been enabled or disabled.
Number of configured bandwidth contracts on the controller.
Number of times a two different stations have attempted to use the same IP
address (IP spoofing).
Number of reported ping, SYN and session attacks.
Licensing
Base operating system
Command Mode
Enable or Config mode on master or local
controllers
show aaa state configuration | 627

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerconnect w-series

Table of Contents