Dell PowerConnect W-7200 Series Reference Manual page 787

show ap mesh debug current-cluster
show ap mesh debug current-cluster {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
Description
Display information for the mesh cluster currently used by a mesh point or mesh portal.
Syntax
Parameter
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
Examples
The output of the command below shows mesh cluster profile configuration parameters for the mesh cluster
currently used by an AP named "mp2."
(host) #show ap mesh debug current-cluster ap-name mp2
AP "mp2" Current Cluster Profile: default
-----------------------------------------
Item
----
Cluster Name
RF Band
Encryption
WPA Hexkey
WPA Passphrase
The output of this command includes the following information:
Column
Cluster Name
RF band
Encryption
WPA Hexkey
WPA Passphrase
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Show mesh cluster data for an AP with a specific name.
Show mesh cluster data for a specific Basic Service Set Identifier (BSSID) on an AP. An
AP's BSSID is usually the AP's MAC address.
Show mesh cluster data for an AP with a specific IP address. Enter the IP address in
dotted-decimal format.
Value
-----
smettu-mesh
a
opensystem
N/A
********
Description
Name of the mesh cluster using this profile
The RF band in which the mesh point or mesh portal operates:
g = 2.4 GHz
l
a = 5 GHz
l
Data encryption setting for the mesh cluster profile.
opensystem—No authentication and encryption.
l
wpa2-psk-aes—WPA2 with AES encryption using a preshared key.
l
The WPA pre-shared key (only for mesh cluster profiles using WPA2 with AES encryption).
The WPA password that generates the preshared key (only for mesh cluster profiles using
WPA2 with AES encryption).
show ap mesh debug current-cluster | 787