audit-trail
audit-trail [all]
Description
This command enables an audit trail.
Syntax
Parameter
all
Usage Guidelines
By default, audit trail is enabled for all commands in configuration mode. Use the show audit-trail command to
display the content of the audit trail.
Example
The following command enables an audit trail:
(host) (config) #audit-trail
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Platforms
All platforms
168 | audit-trail
Description
Enables audit trail for all commands, including enable mode commands. The audit-trail
command without this option enables audit trail for all commands in configuration mode.
Licensing
Base operating system
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide