Dell PowerConnect W-7200 Series Reference Manual page 200

controller-ipv6
controller-ipv6 [loopback|vlan <VLAN ID>]
no ...
Description
This command sets the default IPv6 address of the controller to the IPv6 loopback interface address or a specific
VLAN interface address.
Syntax
Parameter
loopback
vlan
VLAN ID
Usage Guidelines
This command allows you to set the default IPv6 address of the controller to the IPv6 loopback interface address or
a specific IPv6 VLAN interface address. If the controller IPv6 command is not configured then the controller IP
defaults to the loopback interface address. If the loopback interface address is not configured then the first
configured VLAN interface address is selected. Generally, VLAN 1 is the factory default setting and thus becomes
the controller IP address.
Example
The following command sets the controller IP address to VLAN interface 6.
(host) (config) #controller-ipv6 vlan 6
Related Commands
(host) (config) #show controller-ipv6
Command History
This command is introduced in ArubaOS 6.1.
Command Information
Platform
Available on all platforms
200 | controller-ipv6
Description
Sets the controller IP to the loopback interface.
Set the controller IP to a VLAN interface.
Specifies the VLAN interface ID.
License
Base operating system
Default
disabled
—
—
Command Mode
Config mode on master controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide