Dell PowerConnect W-7200 Series Reference Manual page 502

remote-node-masterip
remote-node-masterip <masterip>
ipsec key <pre-shared key>
ipsec-factory-cert
Description
This command configures the IP address and preshared key or factory-installed certificate for the Remote-Node
Master on a local Remote Node.
Syntax
Parameter
<masterip>
ipsec <key>
ipsec-factory-cert
Usage Guidelines
Use this command on a local Remote Node to configure the IP address and preshared key for communication with
the master Remote Node. On the master controller, use the
remote-node-localip command to configure the IP address and preshared key for a local Remote Node.
NOTE: Changing the IP address of the master on a local Remote Node requires a reboot of the local Remote Controller.
Example
The following command configures the Remote-Node Master on a local Remote Node:
(host) (config) #remote-node-masterip 172.16.0.254 ipsec rhyopevs
Command History
Release
ArubaOS 3.0
ArubaOS 6.1
Command Information
Platform
Available on all platforms
502 | remote-node-masterip
Description
IP address of the master Remote Node.
Secure communication between a Remote-Node and Remote-Node master by defining a preshared
key, which must be between 6-64 characters.
Secure communication between a Remote-Node and Remote-Node master by identifying a factory-
installed certificate on the Remote-Node Master.
Modification
Command introduced.
The ipsec-factory-cert parameter was introduced to allow certificate-based
authentication of Remote-Node Masters.
License
Available in the base operating system
Command Mode
Config mode on local Remote Nodes.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide