Dell PowerConnect W-7200 Series Reference Manual page 956

Parameter
services
session
ap-name <ap-name>
counters
ip-addr <ip-address>
ipv6
table
station
counters
mac <macaddr>
tcp
app <app>
counters
tunnel
table
tunnel
counters
ipv4
ipv6
956 | show datapath
Description
Displays the datapath services table statistics including protocol, port and service.
Displays datapath session statistics
Name of AP
Displays counters statistics including current entries, high water mark, maximum
entries, total entries, allocation failures, duplicate entries, cross linked entries,
number of reverse entries and maximum link length.
IP address of the AP.
Displays datapath IPv6 session entries and statistics including current entries, high
water mark, maximum entries, total entries, allocation failures, duplicate entries,
cross linked entries, number of reverse entries and maximum link length.
Displays all the IP flows of a wireless device or Dell AP. Statistics include table
entries including source IP, destination IP, protocol, SPort, DPort, Cntr, priority,
ToS, age, destination, TAge and flags.
Displays datapath station association table statistics.
Display the current and high water mark amount of 802.11 associated wireless
devices on an Dellcontroller. Values output from this command represent the
water-marks since the last boot of the controller. This is the same value obtainable
from the Num Associations output from the show stm connectivity command.
Hardware address, in hexadecimal format.
Displays contents of the tcp tunnel table. This command displays all tcp tunnels
that are terminated by the controller,
Name of the application.
Displays the tcp tunnel statistics.
Displays the tcp tunnel table.
This command displays the Datapath Station Table Statistics detail.
Display all associated wireless devices on the Dellcontroller with their
corresponding AP BSSID and VLAN ID.
Displays the wireless device is associated with the correct encryption type (if the
device is associated to an AP BSSID that has encryption enabled and verifies
whether the Dellcontroller is having a problem in decrypting the wireless device's
frames.
Displays contents of the datapath tunnel table. This command displays all the
tunnels that are terminated by the controller, including Dell APs' GRE tunnels. For
example, a GRE tunnel is created and terminated on the Dellcontroller for every
SSID/BSSID configured on the Dell AP.
Tunnel counters.
Displays the tcp tunnel table filtered on IPv4 entries.
Displays the tcp tunnel table filtered on IPv6 entries.
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide