Dell PowerConnect W-7200 Series Reference Manual page 807

Parameter
ap-name
bssid
ip-addr
mesh-list
pot-ap-list
pot-client-list
routers
wired-mac
ap-name <ap-name>
bssid <bssid>
ip-addr <ip-addr>
ap-bssid <ap-
bssid>
enet-mac <enet-
mac>
Examples
The output of the command displays the Monitored AP table, which lists all the APs monitored by a specified AP or
BSSID.
(host) #show ap monitor ap-list
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Description
Name of Access Point
BSSID of Access Point
IP Address of Access Point
Show list of Mesh APs being monitored.
Display the Potential AP table. The Potential AP table shows the following data:
bssid: the AP's Basic Service Set Identifier.
l
channel: The AP's current radio channel
l
phy type: The radio's PHY type. Possible values are 802.11a, 802.11a-HT-40, 802.11b/g,
l
802.11b/g-HT-20.
num-beacons: Number of beacons seen during a 10-second scan
l
tot-beacons: Total number of beacons seen since the last reset.
l
num-frames: Total number of frames seen since the last rest.
l
mt: Monitor time; the number of timer ticks elapsed since the controller first
l
recognized the AP.
at: Active time, in timer ticks.
l
ibss: Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the bssid has
l
detected an ad-hoc BSS (an ibss bit in an 802.11 frame).
rssi: The Receive Signal Strength Indicator (RSSI) value displayed in the output of this
l
command represents signal strength as a signal to noise ratio. For example, a value of
30 would indicate that the power of the received signal is 30 dBm above the signal
noise threshold.
Display the Potential client table. The Potential Client table shows the following values:
last-bssid: the Last BSSID to which the client associated.
l
from-bssid,
l
to-bssid
l
mt:Monitor time; the number of timer ticks elapsed since the controller first
l
recognized the client.
it: Client Idle time, expressed as a number of timer ticks.
l
Show Router MAC Addresses learned. The output of this command includes the router's
MAC address, IP address and uptime.
Show Wired MAC Addresses learned.
Show data for an AP with a specific name.
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic Service
Set Identifier (BSSID) is usually the AP's MAC address.
Show data for an AP with a specific IP address by entering its IP address in dotted-
decimal format.
Include the optional ap-bssid <ap-bssid> parameters to show how the AP is monitoring
information for another AP with a specific BSSID.
Include the optional enet-mac <enet-mac> parameters to show how the AP is monitoring
information for an interface with a specific Ethernet MAC address.
ap-name al12
show ap monitor | 807