Chapter 5: Configure System For Use; Configure Idrac - Dell EMC PowerProtect DD6400 System Expansion Manuallines

Topics:
•

Configure iDRAC

• Configure serial over LAN (SOL)
• Change the iDRAC network port
• Enable administrative communication
• Accepting the End User License Agreement
• Run the configuration wizard
• Configuring the system with the configuration wizard
• License
• Network
• Passphrase
• File System
• Settings
• Selecting and configuring Secure Remote Services delivery
Configure iDRAC
About this task
The PowerProtect system requires that the Integrated Dell Remote Access Controller (iDRAC) is configured for system upgrade
and maintenance operations. Additionally, the system supports the use of iDRAC to change security settings, and remotely
power the system on and off.
CAUTION: Do not use iDRAC to change the storage configuration, system settings, or BIOS settings, as making
changes will impact system functionality. Contact Support if changes are required in any of these areas.
The system uses the following key mapping for console redirection:
Use the <ESC><1> key sequence for <F1>
Use the <ESC><2> key sequence for <F2>
Use the <ESC><3> key sequence for <F3>
Use the <ESC><0> key sequence for <F10>
Use the <ESC><!> key sequence for <F11>
Use the <ESC><@> key sequence for <F12>
Use the <ESC><Ctrl><M> key sequence for <Ctrl><M>
Use the <ESC><Ctrl><H> key sequence for <Ctrl><H>
Use the <ESC><Ctrl><I> key sequence for <Ctrl><I>
Use the <ESC><Ctrl><J> key sequence for <Ctrl><J>
Use the <ESC><X><X> key sequence for <Alt><x>, where x is any letter key, and X is the
upper case of that key
Use the <ESC><R><ESC><r><ESC><R> key sequence for <Ctrl><Alt><Del>
Steps
1. Connect to the system serial console or connect KVM to the system.
2. Reboot the system.
3. During the system boot process, press F2 to access the BIOS menu.
4. Select iDRAC Settings.
5. Select Network.
30 Configure System for Use
Configure System for Use
5