Table of Contents
Advertisement
Install the Access Point
Procedure
1. Insert the safety cable through the security cable hole on the metal base of the access point.
Figure 18: Security cable hole on the access point
Callout
1
2. Push the cable through the security hole until you see it come out on the other side of the metal
base.
3. Insert a lock through the looped ends of the cable and lock it in place.
Power or Pressure Washing Guidelines
Details about how to safely pressure wash the surface around the access point.
Before You Begin
Ensure that your pressure washing equipment fulfills the following specifications:
•
Pressure washer Pounds per Square Inch (PSI) must be less than 4000.
•
Do not use a nozzle with less than 15-degree washer tip.
•
The pressure washing nozzle must be at least 24 in. away from the access point.
Cleaning solution specifications:
•
Use only commercially available cleaning agents and solvents to clean the access point.
•
Use only commercially available ice-melt products.
Warning
Do not use cleaning agents, solvents, and ice-melt products that are flammable, contain
polycarbonate or rubber dissolving ingredients, uses refined petrochemical materials, and any
other materials that can damage a concrete surface.
Power or Pressure Washing Guidelines
Description
Security cable hole
ExtremeWireless™ AP560i Access Point
47
Advertisement
Table of Contents
