Required Information, Tools, And Equipment - Cisco TelePresence System 1000 Hardware Options & Upgrade Manual

Upgrading a CTS-3000 to a CTS-3200: Summary Steps
Table legs are unstable until they are fully attached to the tabletop. Do not use unattached table legs
Warning
as tabletop supports while you attach tabletop segments. They can fall and cause injury or damage.
Cisco suggests you use the accessory cabinets to support and stabilize the table segments as you
install them.
Power down the system. See the
Step 1
Caution Make sure all system power is turned off before beginning the upgrade procedure.
Step 2 Replace the existing primary with the new primary codec. See the
section on page 5-3
Replace the lenses in the camera cluster with the lenses for the CTS-3200. See the
Step 3
Replacing the Camera Lenses" section on page 5-6
Add the audio extension unit to the rear of the display assembly. See the
Step 4
Expansion Unit" section on page 5-8
Add the auxiliary control unit to the rear of the display assembly. See the
Step 5
Unit" section on page 5-10
Add the second row table, microphones, I/O modules, and power and signal cables. See the
Step 6
the Second Row Table Assembly" section on page 5-12
Route the cables for the second row table and attach and route the cables for the audio extension unit and
Step 7
auxiliary control unit. See
If you require additional information, refer to the
Note
Cisco TelePresence System 3200 Assembly, Use & Care, and Field Replacement Unit
Configure Cisco Unified Communications Manager and power on the system. See the
Step 8
System" section on page 5-71
Step 9 Perform the first-time setup steps and reliagn the cameras using the instructions in the
Cisco TelePresence System Administrator's

Required Information, Tools, and Equipment

To perform the upgrade from the CTS-3000 to a CTS-3200, you need the following information, tools,
and equipment:
•
•
•
•
•
•
•
Cisco TelePresence System
5-2
Chapter 5
for more information.
for more information.
"Attaching and Routing Cables" section on page 5-63
Cisco TelePresence System Release 1.4 Administrator's Guide, OL-13676-03
Release Notes for Cisco TelePresence System, Release 1.4, OL-12074-05
Power screwdriver with 2.5, 3, and 6 mm (standard or round) Allen bits, or standard 2.5, 3, and 6 mm
Allen wrenches
Manual screwdrivers, Phillips and flat head types
Metric wrenches, 10 to 15 mm
Masking tape
Laptop computer attached to network
Upgrading a Cisco TelePresence System 3000 to a Cisco TelePresence System 3200
"Powering Off the System" section on page 5-3
for more information.
for more information.
for more information.
"Routing Power and Signal Cables"
for more information.
Guide.
for more information.
"Replacing the New Primary Codec"
"Removing and
"Adding the Audio/Video
"Adding the Auxiliary Control
for more information.
chapter of the
Guide.
"Powering On the
OL-16441-01
"Building