Zone And Zone Set Analysis - Cisco nexus 5000 series Cli Configuration Manual

Zone and Zone Set Analysis

S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
A merge failure occurs when a switch supports more than 2000 zones per VSAN but its neighbor does
Note
not. Also, zone set activation can fail if the switch has more than 2000 zones per VSAN and not all
switches in the fabric support more than 2000 zones per VSAN.
To delete zones and compact the zone database for a VSAN, perform this task:
Command
Step 1
switch# configuration terminal
switch(config)#
Step 2
switch(config)# no zone name zone-name vsan
vsan-id
Step 3
switch(config)# zone compact vsan vsan-id
Zone and Zone Set Analysis
To better manage the zones and zone sets on your switch, you can display zone and zone set information
using the show zone analysis command.
The following example shows how to display full zoning analysis:
switch# show zone analysis vsan 1
The following example shows how to display active zoning analysis:
switch# show zone analysis active vsan 1
See the Cisco Nexus 5000 Series Switch Command Reference for the description of the information
displayed in the command output.
Default Settings
Table 1-4
Table 1-4
Parameters
Default zone policy
Full zone set distribute
Enhanced zoning
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide
1-24
lists the default settings for basic zone parameters.
Default Basic Zone Parameters
Chapter 1 Configuring and Managing Zones
Purpose
Enters configuration mode.
Deletes a zone to reduce the number of zones
to 2000 or fewer.
Compacts the zone database for the specified
VSAN to recover the zone ID released when
a zone was deleted.
Default
Denied to all members.
The full zone set(s) is not distributed.
Disabled.
OL-16597-01