Ivr-2 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message IVR-2-DEVICE_FCID_REWRITE_FAILURE: Failure while programming FCID
rewrite entries for pWWN [chars] on incoming VSAN [dec]. Device may not be able
to communicate with its peer devices.
Error Message
(FCID:[chars], native VSAN [dec] native AFID [dec]) may not be exported to other
VSANs (for Inter-VSAN zoning) because it has come online in VSAN [dec] AFID [dec].
Error Message IVR-2-DEVICE_ON_WRONG_NATIVE_VSAN: Device with port WWN [chars]
(FCID:[chars], native VSAN [dec]) may not be exported to other VSANs (for
Inter-VSAN zoning) because domain [hex] exists in VSAN [dec].
Error Message IVR-2-DEVICE_STATE_INCOMPATIBLE_WITH_NAT_MODE: State for device with
port WWN [chars] could not be restored because it was incompatible with the current
NAT mode([dec]). This probably happened because NAT mode was modified without
completely deactivating the active IVR zoneset.
Cisco MDS 9000 Family System Messages Reference
2-168
of sync. with this peer. We recommend that you discard this CFS session using ivr abort command
and then re-enter the configuration changes. You can alternatively use Fabric Manager and/or Device
Manager instead of the command line method.
Recommended Action No action is required.
Explanation Device failed to program the FC ID rewrite entries; this probably occurred because the
hardware ran out of FC ID rewrite entries. This can happen if there are too many devices in an
inter-VSAN routing (IVR) zone, or there are too many local VSANs in the VSAN topology.
Recommended Action Reduce the number of devices involved in inter-VSAN routing (IVR) in the
active IVR zone set. Also, reduce the number of redundant transit VSANs, if any.
Cisco MDS SAN-OS Release 2.1(1a).
Introduced
IVR-2-DEVICE_ON_WRONG_NATIVE_AFID_VSAN: Device with port WWN [chars]
Device has come online on a different AFID/VSAN from the configured native
Explanation
AFID/VSAN, or the device does not satisfy unique domain criteria.
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 2.1(1a).
Device has come online on a VSAN different from the configured native VSAN, or the
Explanation
device does not satisfy unique domain criteria.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation This can happen if the Network Address Translation (NAT) mode is modified without
completely deactivating the active inter-VSAN routing (IVR) zone set.
Reboot the switch.
Recommended Action
Cisco MDS SAN-OS Release 2.1(1a).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01