Port-3; Port-5 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PORT-5-IF_BRINGUP_NOT_ALLOWED_PORT_CONFIG_FAILURE: Interface [chars]
is not allowed to be operational due to port config failure for reason: [chars]
([hex]).
Error Message PORT-5-IF_DOWN_ADMIN_DOWN: Interface [chars] is down (Administratively
down).
Error Message
(Error disabled - bit error rate too high).
Error Message
due to channel mis-configuration on local or remote switch).
Error Message
Cisco MDS 9000 Family System Messages Reference
2-234
Explanation Check interface configuration.
Try to change the configuration on the interface with the current available
Recommended Action
hardware capability.
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Interface has been configured to be administratively down.
Explanation
Enter the CLI commands config terminal, interface, no shutdown or use a
Recommended Action
similar Fabric Manager procedure to bring up the interface.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
PORT-5-IF_DOWN_BIT_ERR_RT_THRES_EXCEEDED: Interface [chars] is down
The port has detected a bit error rate too high in frames received from attached device.
Explanation
Recommended Action Check the attached device and replace it if needed.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
PORT-5-IF_DOWN_BUNDLE_MISCFG: Interface [chars] is down (Isolation
Explanation One port across a link is part of a PortChannel while the other is not.
While adding or deleting a member port from a PortChannel, both ports across
Recommended Action
the link should be added or deleted. No operation should be performed on either port until they are
both added or deleted.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
PORT-5-IF_DOWN_CFG_CHANGE: Interface [chars] is down(Config change).
FCIP interface temporarily down because of reconfiguration.
Explanation
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01