Vrrp_Eng-3; Vrrp_Eng-4 - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
VRRP_ENG-5
Error Message VRRP_ENG-5-INTERFACE_DOWN: Cannot start the VR[chars] [dec] since the
interface [chars] is down.
Error Message VRRP_ENG-5-INTERFACE_STATE_CHANGE: Interface [chars] state changed to
[chars].
Error Message VRRP_ENG-5-STARTING: VRRP Engine service started.
Error Message VRRP_ENG-5-VR_STATE_CHANGE: VR[chars] ID [dec] on interface [chars]
state changed to [chars].
VRRP_ENG-6
Error Message VRRP_ENG-6-VSHA_RESULT: VR ID [dec] on interface [chars] state change
request result [chars].
OL-15956-01
Explanation The specified VR is enabled but cannot change state from init. The specified interface
is down or does not have a primary IP address configured.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
The interface specified has changed state. This could have triggered a VRRP status
Explanation
change.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
The service successfully started.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
The status of the specified virtual router has changed to [chars].
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
Explanation The virtual router specified has received an invalid advertisement.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Cisco MDS 9000 Family System Messages Reference
2-445