Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 442

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message
while running the Nvram test.
Error Message
fc[dec]/[dec] failed.
Error Message SYSTEMHEALTH-4-OHMS_SUP_BOOTFLASH_ERRORS: Bootflash test has
encountered an error on module [dec]. Reason: [chars].
Error Message SYSTEMHEALTH-4-OHMS_SUP_CF_CRC_TEST_FAILING: Compact Flash firmware
CRC checksum validation starting to fail on module [dec].
Error Message SYSTEMHEALTH-4-OHMS_SUP_CF_REFLASH_TEST_FAILING: Compact Flash
firmware refresh procedure starting to fail on module [dec].
Cisco MDS 9000 Family System Messages Reference
2-406
SYSTEMHEALTH-4-OHMS_NVRAM_ERRORS: Too many errors on module [dec]
NVRAM test has had too many errors while running.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.0(1).
Introduced
SYSTEMHEALTH-4-OHMS_SERDES_FAILED: Serdes loopback test on interface
System Health SERDES test failure.
Explanation
Recommended Action No action is required.
Introduced Cisco MDS SAN-OS Release 1.3(1).
Compact flash test errors on supervisor module.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.3(1a).
Introduced
Compact flash firmware CRC checksum may be bad on this module.
Explanation
Recommended Action Schedule a downtime and replace the compact flash on the affected module.
Do not attempt any hitless upgrades or downgrades.
Cisco MDS SAN-OS Release 3.1(3).
Introduced
Compact flash may be bad on this module.
Explanation
Schedule a downtime and replace the compact flash on the affected module. Do
Recommended Action
not attempt any hitless upgrades or downgrades.
Cisco MDS SAN-OS Release 3.1(3).
Introduced
Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01