Vpm-Slot# Messages; Vrrp_Cfg Messages - Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual

Chapter 2 System Messages and Recovery Procedures for the Cisco MDS 9000 Family
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

VPM-SLOT# Messages

This section contains the virtual port manager slot (VPM-SLOT) messages.
VPM-SLOT#-2
Error Message
critical error please reboot ILC.

VRRP_CFG Messages

This section contains the Virtual Router Redundancy Protocol (VRRP_CFG) messages.
VRRP_CFG-2
Error Message
VRRP_CFG-3
Error Message
OL-15956-01
VPM-SLOT#-2-CPP_CATASTROPHIC_ERROR: ERROR: Component ([chars]) caused
The listed component caused a critical error.
Explanation
Restart the line card.
Recommended Action
Cisco MDS SAN-OS Release 2.0(1b).
Introduced
VRRP_CFG-2-ALLOC_MEMORY: Memory allocation failed.
The service failed to allocate a block of dynamic memory.
Explanation
Check the system memory. If memory is low, reset the switch.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
VRRP_CFG-3-INIT_FAILED: Initialization failed. Component [chars].
The service failed to start. The failure occurred while initializing the component shown
Explanation
in the error message.
Enter the show processes CLI command or use a similar Fabric
Recommended Action
Manager/Device Manager procedure to check the status of the other processes and debug the
specified component.
Introduced Cisco MDS SAN-OS Release 1.2(2a).
Cisco MDS 9000 Family System Messages Reference
2-441