Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 426
Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs
Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
- Command reference manual (1640 pages) ,
- Configuration manual (700 pages) ,
- Installation manual (288 pages)
Table of Contents
Advertisement
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message SYSMGR-5-CFGWRITE_STARTED: Configuration copy started (PID [dec]).
Error Message
(PID [dec]).
Error Message SYSMGR-5-DELETE_BINARY_STARTUP_STARTED: Deletion of binary startup
configuration started (PID [dec]).
Error Message
successfully performed.
Error Message
since send failed: [chars] (error-id [hex]).
Cisco MDS 9000 Family System Messages Reference
2-390
On the active supervisor, this message indicates that the system has started to service a
Explanation
copy running-config startup-config CLI command requested by the user. On the standby
supervisor, this message indicates that the system is synchronizing the startup configuration from
the active supervisor.
Recommended Action
No action is required.
Introduced
Cisco MDS SAN-OS Release 1.2(2a).
SYSMGR-5-CONVERT_STARTUP_STARTED: Configuration conversion started
The system has started conversion of the startup configuration. This occurs either on
Explanation
system boot or during the course of an upgrade.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Explanation
The system is the binary startup configuration, because of an error in the conversion of
the startup conversion.
If you purchased Cisco support through a Cisco reseller, contact the reseller
Recommended Action
directly. If you purchased support directly from Cisco Systems, contact Cisco Technical Support.
Introduced
Cisco MDS SAN-OS Release 2.0(1b).
SYSMGR-5-HANDSHAKE_DONE: Handshake with service "[chars]"
Handshake with the listed service was successful.
Explanation
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
SYSMGR-5-HANDSHAKE_FAILED: Handshake with service "[chars]" failed
Handshake with a service failed because system manager could not send handshake
Explanation
response to it.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01
Advertisement
Table of Contents
