Cisco AJ732A - MDS 9134 Fabric Switch Messages Manual page 282

Cisco mds 9000 family system messages reference (ol-15956-01, april 20078)
Hide thumbs Also See for AJ732A - Cisco MDS 9134 Fabric Switch:
Table of Contents

Advertisement

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Error Message PORT-5-IF_DOWN_PEER_CLOSE: Interface [chars] is down(TCP conn. closed
by peer).
Error Message
by peer).
Error Message PORT-5-IF_DOWN_PORT_ACT_LICENSE_NOT_AVAILABLE: Interface [chars] is
not allowed to come up (port activation license not available.
Error Message PORT-5-IF_DOWN_PORT_BIND_FAILURE: Interface [chars] is down(Isolation
due to port bind failure).
Error Message
due to FICON).
Cisco MDS 9000 Family System Messages Reference
2-246
The FCIP peer connected to this interface closed the TCP connection.
Explanation
Enter the show interface command or use a similar Fabric Manager procedure
Recommended Action
to provide the peer IP address of this FCIP interface. Check to see why the peer closed the TCP
connection.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
PORT-5-IF_DOWN_PEER_RESET: Interface [chars] is down(TCP conn. reset
TCP connection to the FCIP peer got reset.
Explanation
Enter the show interface and show ip route CLI commands or use a similar
Recommended Action
Fabric Manager/Device Manager procedure to provide the IP address of the peer and the route used
to connect to this FCIP peer. Check to see why the peer reset the TCP connection.
Cisco MDS SAN-OS Release 1.2(2a).
Introduced
Assign a port activation license to this port or install additional port activation licenses
Explanation
as needed.
No action is required.
Recommended Action
Cisco MDS SAN-OS Release 3.1(2).
Introduced
Port binding failed on this port.
Explanation
Recommended Action
Check the port binding database to ensure that the remote port is allowed to
connect to this port.
Cisco MDS SAN-OS Release 1.3(1).
Introduced
PORT-5-IF_DOWN_PORT_BLOCKED: Interface [chars] is down(Port blocked
The port has been blocked by the FICON configuration.
Explanation
Unblock the port in the FICON configuration.
Recommended Action
Cisco MDS SAN-OS Release 1.3(1).
Introduced
Chapter 2
System Messages and Recovery Procedures for the Cisco MDS 9000 Family
OL-15956-01

Advertisement

Table of Contents
loading

Table of Contents